Making Custom Made Usb Drives

By Tammie Caldwell


Ever since USBs have become pretty much a necessity for everyone who owns a computer these days, many people have been wanting to spruce up their thumb drives. Now there are actually stores or people who would create custom made usb drives for these type of people. Now with a few materials at home and some effort, it is actually possible to save a lot of money and create custom thumb drives right at home.

Now the first step in doing this would be to get a thumb drive and take out the existing case. It is important to get the internals because this is what will be used to make the custom made drive. One has to be very careful though because the internal part of the drive is quite sensitive.

One very important thing to take note in this step is that sometimes one would be needing a screwdriver. Although there are no screws found here, the outer covering may be hard to take off with just bare hands. So with a screwdriver, he will have an easier time snapping off the existing cover without damaging the inside of the usb.

Now after one has already done this, then the next thing to do would be to think of a new outer covering. Now this is where one can get a little bit artistic. He can actually decide on whatever he would want as an outer covering as the material will not really matter.

Now some of the suggested things to use for this part would be some toys, lego blocks, or even clay if one would like. Of course there is no limit to the things that one can do with this. Now once he has already chosen what he wants to use for his outer covering, he now has to get himself a drill.

In this step, one would have to get a drill because he will need to open up a hole if for example, his toy does not have a hole on top. Now he will be needing a lot of measurements like the width as well as the length. Once he has already drilled the hole, then all he has to do would be to put the usb in.

Finally, he then has to put some epoxy or some super glue around the hole so that the drive will not come out. Now this is one of the most important steps of them all because without it, the thumb drive may definitely fall out anytime. Once he has already applied the epoxy or glue, then he should dry it using a hair dryer or electric fan.

So if one has a little bit of an artistic touch and does not mind putting in some time and effort, then he can make his own custom thumb drive. Now the great thing about this is that it is very cheap to do. No longer will one have to spend a lot of money to make a custom thumb drive. He can just make it at home already without having to go to any store.




About the Author:



No comments:

Post a Comment